[Brumos RSR]

Graham pid='40116' dateline='1725691347']

The teammate is built but I have a few questions based on this car performing poorly in other proxies. Will I need a rear valance and factory interior?

The rear valance is part of the standard Revoslot “body parts”  as supplied, so in my proxy they are expected to be fitted. If the chassis is too close fitting, then up to 1mm of the valance can be sanded off to allow for body float. The factory fitted interior can be replaced with the equivalent Revoslot lightweight part.

I fixed all of the above…. And after kit bashing 3 different GT2s, I have 1 ready to go.  Everything is flat, straight, aligned, glued, trued, squared and mildly lowered but still higher than 1.5mm.   I had no idea these cars sat sooo high until I measured.