[Graham]

Just 5 car places left for the proxy.

[AdeC]

Can I have 3 please Graham

[Graham]

Ok, that leaves just two cars places.

[woodcote]

Can I grab those last two places for Scuderia Woodcote? A Fiat Abarth 1000 TCR in Event 1 and an Alfa 156 for Event 3.

   

Avanti!

[Graham]

Can I grab those last two places for Scuderia Woodcote? A Fiat Abarth 1000 TCR in Event 1 and an Alfa 156 for Event 3.



Avanti!

Hi Andy,
You are very welcome

[Graham]

 Good Morning

I have been asked if its possible to permit the use of  S-can motors Listed in Event 2  in Event 1 in relation to "Mini type" car models which might struggle for handling with the original list of higher rpm motors. I think this is a reasonable request and to be honest I am not quite sure now why this was not the case in the original rules.

So I have revised the wording in the leading page to allow for any motor in Event 2 can also be used in Event 1 and also added a couple of 13K & 16K motors into the Event 1 motor list which might be appropriate for these small car models.

[Kevan]

The motor list for E.1 and E.2 is confusing.

S-can only in E.2, Revo motor in E.1 and E.3 but not E.2.

Wouldn't it make sense to limit the motors in E.1 to 20k max, as you say they're much smaller than the other two events and on much narrower tyres.

[Graham]

The motor list for E.1 and E.2 is confusing.

S-can only in E.2, Revo motor in E.1 and E.3 but not E.2.

Wouldn't it make sense to limit the motors in E.1 to 20k max, as you say they're much smaller than the other two events and on much narrower tyres.

The motors in Event 1 are intended as an open Class to allow for the Revoslot & Slot it standard cars, thats why it allows up to 21K Max.
E2 is specific to in line Scalex modified cars so is limited to only S-Can Max 21K motors
E3 is also an open class and includes long can motors and max 21K

[Graham]

Inspiration for Event 2 perhaps

   

[AdeC]

Any chance of getting the Volkswagen Golf Mk1 included in Event 1?