[Graham]

Event 3:

There's some tyre grooves occurring on Makem Movers Viper and on Harrisons Supra, presumably from contact with loose interiors. Don't know if this has been addressed in the past or is a continuing issue, but I'm happy to investigate if needs be





Then there's Ruscillo's Mercedes and its rear wheel which jettisoned last round. I can glue this back on, but as a side note there is only a very short amount of axle protruding from the bushing



Team Cube's Ferrari is very short and had slid off the card in transit leading to the braids getting a bit squashed up.  These have now been smoothed out and I'll try and find something to pack in front of the car to prevent it reoccurring

Ruscillo is aware of the short axle issue but would like you glue the wheel back on if you can without gluing it to the bushing please.
I think both the entrants Harrison Racers and Makem would like you address the interior rubbing issues if you can, I think the Viper was an issue at the start as the interior was stressed into position, so that tyre damage probably was done early on. I refitted it but that’s not to say it has stayed in place. The Supra to my knowledge has been OK until recently, so probably this tyre damage is very recent, so please try to refit the interior on that one.

Oxo cube mentions replacing a missing front wheel grub screw on ALS Corvette, but I don’t recollect anyone raising an issue with your Porsche front wheel ?