[OXO cube]

Can I ask for volts to be run either the same or less than qualifying moving forward? I assume your proxy is looking to maximize each car, deslots and offs hurt those chance, I believe.

hi brumos . the change in voltage was a one off ( forgive the pun )
i always use 10v on my track , it just seems to work better on less grippy SS plastic , which imo results in less offs , and gives a truer reflection of each cars capabilities especially on a home track   , this was how i ran qualifying 
when Mark ( the driver ) arrived , he wanted to run at 12v , and after a long discussion and quick perusal of the host notes supplied by Graham , it was decided 12v was to be used 
this is most definitely the main reason qualifying didn't fully reflect the race ( different drivers and different voltage )
rest assured different voltages  will not happen again , an oversight on my part , as you say the volts will remain the same for both parts of the event ( not sure about lower for the race though )
although different drivers for qualifying and racing will be used , which is often seen in other proxies 
i thought Mark did a great job driving on an unfamiliar track with very very few offs at the agreed 12v , props to him 
also the different tracks , surfaces , drivers etc etc are the proxy challenge , although i realise it is easy for me to be relaxed , especially since i am nowhere near the pointy end where one poor result can make a huge difference 
btw both your cars are a credit and i have no doubt will do well 

Kev