[woodcote]

   

Nostalgia "Micro Scalextric 2019" Winter Series Regulations

• Chassis: New Micro Scalextric 2019 version with FN20 slim can motor. Two holes may be drilled to attach wheelie bar to rear of chassis. Side tabs may be removed to allow body fitment. No other modification to chassis. Components cannot be glued.
  
• Motor: Unmodified original "Micro Scalextric 2019" FN20 slim can motor. Original resistors and capacitor between pick-ups and motor must not be removed. Plastic heat plate may be retained or removed.
  
• Traction magnets: Two original "Micro Scalextric 2019" magnets in original position, flush with bottom of chassis. Orientation may be changed (magnets can be flipped).
  
• Braid plate: "Micro Scalextric 2019" braid plate with fixed braids. Fixing screw must be present, but can be replaced with your own choice.
  
• Braids: Original braids fitted to braid plate only.
  
• Axles and gears: Standard "Micro Scalextric 2019" front and rear axles. Original "Micro Scalextric 2019" 7T pinion + "Micro Scalextric 2019" 25T crown gear.
  
• Wheels: Any front and rear wheels may be used.
  
• Tyres: Any single compound tyre. Maximum diameter on wheel is 0.500” or 12.70mm.
  
• Body: Any injection moulded or cast resin body. No lexan bodies. Body must be in the 'Nostalgia' theme of pre-1979 cars, including modern Pro Mod versions of pre-1979 models. Fixing can be by any means, including screw post, double-sided sticky pads, DIY mounting clips etc.
  
• Maximum width: 35mm or 1.378”.
  
• Weight: Minimum weight of entire car 23g. Ballast may be added to body only.
  
• Wheelie bars: permitted.
  

   

Any questions or problems, just ask.