[woodcote]

   

Micro Scalextric Street Stock Winter Series Regulations

• Chassis: Micro Scalextric 1995-2018 version with braids. May be ‘narrow’ or ‘wide’ versions, depending on body fitted. No cutting, drilling or any other modification to chassis. Components cannot be glued.
  
• Motor: Unmodified standard Micro Scalextric motor with ‘flywheel’ between commutator and armature stacks. Minimum 10 ohm armature (no low-ohm 'My First Scalextric' battery set cars). Original resistors and capacitor between pick-ups and motor may be removed.
  
• Traction magnets: Two original Micro Scalextric magnets in original position, flush with bottom of chassis. Orientation may be changed (magnets can be flipped).
  
• Braid plate: Any 1995-2018 Micro Scalextric braid plate with plastic guide flag or metal pin.
  
• Braids: Any braids – steel, copper or plated. Must not be soldered to chassis components.
  
• Axles, wheels & gears: Standard Micro Scalextric front axle and wheels. Standard Micro Scalextric rear axle, wheels and Micro Scalextric 7T pinion + Micro Scalextric 25T crown gear.
  
• Tyres: Any single compound tyre. Maximum diameter on wheel is 0.476” or 12.09mm.
  
• Body: Any Micro Scalextric closed wheel saloon or GT body – street-style or tuners liveries please. Re-paints most welcome. No cutting or sanding of wheel arches or of any other external surface.
  
• Maximum width: 35mm or 1.378”.
  
• Weight: Minimum weight of entire car 23g. Ballast may be added to body only.
  
• Wheelie bars: not permitted.
  

This is what the motor needs to look like...