[munter]

I have one of these chassis. I bought it out of interest and have built it up. There have been a couple of motor changes from wild to mild.
Wheel changes too from wide to narrow but there is a question I have that puzzles me.

Why are the body mounting holes on the central chassis piece when the outer pans are hinged? this is a plumber design ie the outer pans are hinged from the front. To me the body should be mounted to the pans so I did that.

I made some changes as I built mine....front axle tube, central cross brace, pans drilled and counter punched/sunk, all joins soldered.

Another issue I faced was if the body was mounted at a scale height the chassis sides would be visible (I dont like that) so it had to be low.