[Graham]

Its been a while since I posted my ideas on the Touring cars Proxy, I have been recently revisiting it again (because it is my nature) the earlier Plans and decided on some changes.

The first one is that I think the Event 1 for small touring cars was too broad, so I am narrowing the car list to the more conventional list for under 2.5 Litre cars, but additionally in an attempt to make it "more of a challenge" I am limiting the rear wheel track to 52mm (which is actually the track of the current Slot it Datsun). I feel this restriction might encourage more variety of Narrow track cars like the Minis, Imps & Cortinas to make an appearance ?? The Slot it Datsun will be handicapped by using only std parts as will the Revoslots, the latter could form a sub group if their are sufficient brand entries...we would have to see. 2 car entries are allowed in this Event if one is a Revoslot.

The 2nd change to make it "more of a Challenge" is I have drawn in many more Cars into the "Super & Modern" Event 2, to give the "Modified Standard" builders a wider scope to choose from. Basically this can be for any Scalextric, Carrera, Ninco or SCX type body cars which can be modified.

The 3rd Event for the "Heavyweights" remains more or less intact with some additional cars moved from Event 1.

I have include the use of 3d printed bodies for Event 1 & 3, but they must use 3d printed chassis (same as for areaTA71 limitations)

The motor list is unchanged.

[attachment=42382]

Last chance to protest or air your views.......