[Kevan]

A lot of progress...rear axle needs shortening and wheel inserts are ready to print.

Bodyshell, driver/navigator, wheel inserts and IL pod are resin 3D printed, chassis is 3D printed on a filament printer.

Motor is a short can, not sure what make as it's one acquired from an ex-club member but checks out at about 18k using the Giri app and will be more than enough for a Rally car.

10/26 gearing, Slotingplus guide (needs trimming), independently rotating front wheels, all tyres glued/trued, fronts also hard coated, rears are NSR Supergrips.

One photo shows the car sitting on a 1.5mm ground clearance block I put in the 3D section.

Track test tonight at the club...