[Brumos RSR]

If given the ok by the Race Director, feel free to undo the two screws on the bottom of the chassis to remove the body.  I do not recall if there are washers or grommets on the interior side of the chassis so please be on the look out. Please use a modeler’s glue or Elmer’s to not fog the glass.  Tape holds the interior in place. If you are uncomfortable doing this please contact me prior to starting. Thank you

Brumos, the glass was stuck back in (used a toothpick to apply a small amount or "Glue 'N' Glaze" across the top edge) and the interior was taped back into position.



Just as a note, the glue marks in the middle of the screen were pre-existing, either from original build or previous repair

Pre existing by me no, worries and thank you.