12th-Jul-19, 09:54 PM
Hello Anthony,
I just trried an HO type motor in a PCS 32 chassis and with the pinion shaft aligned to the rear axle centre-line it sits with about 1mm above the sides of the chassis. I reckon it would be an easy fitment using plasticard to fill the gap from the motor frame to the chassis sides (about 1.5mm). HO motor is 9.5mm high, 18 wide and 21,5 long
A Carrera Go! motor might be a possibility having a height of approx 10.8mm. Cutting out the Carrera motor mount from a chassis and gluing it in to the PCS chassis might be do-able. LloydL can probably suggest what pinions would fit and mesh with a standard Scalextric crown gear.
Leo
I just trried an HO type motor in a PCS 32 chassis and with the pinion shaft aligned to the rear axle centre-line it sits with about 1mm above the sides of the chassis. I reckon it would be an easy fitment using plasticard to fill the gap from the motor frame to the chassis sides (about 1.5mm). HO motor is 9.5mm high, 18 wide and 21,5 long
A Carrera Go! motor might be a possibility having a height of approx 10.8mm. Cutting out the Carrera motor mount from a chassis and gluing it in to the PCS chassis might be do-able. LloydL can probably suggest what pinions would fit and mesh with a standard Scalextric crown gear.
Leo
Forum Precepts: Don't hijack or divert topics - create a new one. Don't feed the Troll. http://www.scuderiaturini.com
![[+]](https://slotracer.online/community/images/bootbb/collapse_collapsed.png)