[Graham]

OK
#50 was a bit like me ..... it had a screw loose  
retightened , leaving a little body float .. chassis slightly warped ,so will not close fully 
after tightening screw was still too loose .. pushed a tiny bit of blue tack on top of screw to help secure


#3 axle centralized and a loose wheel secured 
but on further inspection another issue arose , the guide is not secured in the guide post and could become detached from the chassis ?
the guide is sprung and seems to have been glued at some point ? so im not sure about this 
as a result i will not look further into this , but instead will run the car as is and report back on  how it performs 


#27 has been left as is until further instructions 

now onto the track duties 

Kev

I did have to swap the chassis fairly swiftly on the day of the run, as the original one I had in mind to use broke. So I may have missed something, can you take the body top off and email me a photo of the inside of the front guide area. There should be a securing screw holding the guide inside the chassis ?