[Kevan]

Box opening at 1.40pm...  

[Kevan]

I enjoyed looking at the cars, I wasn't sure about the volume but it's fine on the playback.

I would have liked to zoom in more but couldn't find that facility on YT live.

...I need a proper light next time

One or two minor issues to look at before the event on Saturday morning, loose screws, braids needing flattening.

Track will be set at 12V for racing.

[Savage GT]

"An error has occurred. Please try again later" 

[OXO cube]

An error has occurred. Please try again later.

 IOM Youtube ?

[Makem]

I'm getting the same.

No idea what the problem is

Gerry

An error occurred. Please try again later. (Playback ID: fGhzmjEwlS6KRhXi)
Playback ID: buE32TNBBGxD4SoA

[Kevan]

Live stream is over so you'll have to watch it back on YouTube...click the little triangle in the bottom right corner of the black window.

[OXO cube]

still not working bud 
can you post a link to the vid ?
that should work
kev

[BAracer]

The arrow in the bottom right works for me.

[Makem]

Found it here

https://www.youtube.com/watch?v=mcaNpTllM_I


Gerry

[Kevan]

Sorry I didn't do this yesterday, I had to dash out as it was our clubs racing last night.

https://www.youtube.com/live/mcaNpTllM_I...ozOcObCC37

I'd set up the camera in the webcam program, zoomed in to where I wanted, set the focus and was ready...then the stream started and those settings weren't used and there's no on screen adjustments to change the webcam.

Anyway it's a record of the cars.

Quite a few cars had braid badly in need of flattening and straightening.

One car has what sounds like a chunk of lead rattling round inside.

A couple have a screw sticking out as though it's not in properly.

It was good to see cars with blutac in the screw holes (I remembered to do that this time) and a few needing tape over the screws which I'll do today.

On the whole I'd say the standard of car prep is greatly improved.