[Carver]

I used 0,75mm plastic rods to reshape the side scoops.
   

For making the bonnet even lower, I had to remove the narrow plastic bulges.
I have also sanded down the tail quite a bit.
Testing the screen fit once more.
   

For these later changes, I was helped by this pic. It shows a more flat surface of the top of the body than I initially thought it had.
   

A new layer of primer and I think I have come as far as I can get with the general shape, I think it looks Corvettish.
       

Of course a lot of detailing to do, including the grille... Something to chew on!

Carver