[964rh]

I'm banking on the 'best in show' points not having a big influence on the final standings with my entry...

Snap!! 

then again, I'm not expecting that many points to be coming my way for the actual racing either 

[classicchrisk]

Looks like the 35k Scaleauto motor in that. That'll have a phenomenal top speed and plenty of bottom end torque!!

[classicchrisk]

OXO cube

Is that the TR7 that was at Wye Valley?

[classicchrisk]

Now, which one do I enter? The only one I can't send is the red one with the arch extensions, it's too wide for the rules!! It's running an Amato low chassis with Slot It anglewinder pod. My most modified TR7, would have been great on the proxy!

[OXO cube]

OXO cube

Is that the TR7 that was at Wye Valley?

hi , yes it is 
the only differences being the motor
the wye valley motor had loose windings and had begun to unravel 
also narrowed the  rear wheels a little just to give more body clearance 


Kev

[Gpa113]

Now painted and lacquered.   Decals applied and bodyposts eventually fitted, 2 out of the 3 supplied with the chassis were useless 


Running gear sorted, but wheels and tyres are proving tricky 

Hope to have it running tomorrow.....

[Anthony B]

Show us a pic of them upside down please?

[BAracer]

Show us a pic of them upside down please?

There's a photo on page 6

[Nonfractal]

Looks like the 35k Scaleauto motor in that. That'll have a phenomenal top speed and plenty of bottom end torque!!

I'm pretty sure I did not write that...
However, the sc30 is out and the sc0025b is in.
The outlaw is just not the right motor for a proxy.
Alan