[OXO cube]

John , looking at your body prints , it looks like they have been printed vertically ? 
is this the case ? i was wondering if this is the case , what support and bed adhesion settings are you using and , if you are using any slight vertical angle 
especially with regard to the wheel wells and cockpit openings 
i normally print horizontally , which although creates arguably stronger bodies , always leaves a lot of work removing layer lines especially the last few on a flat (ish) plane 
btw i printed your Allen key tool the other day , apart from some slight elephant foot trimming (which is due to my machine), it otherwise fit together like a glove , just an FYI  , nice work 
Kev