[JMay]

Been fed up chasing tools around the desk or from a tray/drawer, so created a tool rack as shown, which screws to the underside of the shelf that runs over my desk in the Summerhouse. The rack has a variety of cut outs to take as shown all the tools I like to have to hand when dabbling with slot cars.

   

Rack prints upside down without supports and is 264 x 61mm square so should fit most FDM printers.

   

Tool rack.stl Size: 1.16 MB  Downloads: 2

And a short version in 2 parts for those with tiny printers.

Tool rack short.stl Size: 1,000.57 KB  Downloads: 1

Cheers
           JMay.