[Kevan]

I had a 'game changer' moment today, my Prusa came with the smooth sheet which works great with a film of glue stick to help release prints done in PETG based filaments.

Today I received a Prusa textured sheet, changed the sheet type in the printer settings and went through the calibration procedure and adjusted 'live Z' down almost 0.5mm (as this sheet is 0.5mm thinner) then did a test print which is a 100mm square 0.3mm thick (which is really useful for interiors actually)...I took the sheet off the machine to cool down on a cold flat surface, when it was cold the print just gently peeled off the sheet.

No glue stick was used this time...this is going to make life soooooo much easier