[JMay]

For a variety of reasons been on a shut down in Q1 of this year, but slowly ramping back up now, and the designs I have been dabbling with are now getting to be printed and finished off. Below is a 1980s generic F3 car in 1/24 scale (draft version shown alongside a SCX 1/32 F1) as this is small enough to still fit on most tracks (overall width is 70mm). 

   

Next picture is the evolved version with numerous tweaks for ride height, chassis to shell fit, driver too small, print issues and utilising 1/24 BRM IL cogs to give a higher ratio to off sett the wheel diameter and ensure reasonable brakes. 

   

Chassis has a 3 point pod separate from the chassis and can be mounted tight /loose or sprung and the rear axle is on 3mm ball races.

IM either here on Slotracer or the FB page for further details.


   

Front wheels are carbon fibre with TPU printed tyres which with the TPU rear wing (virtually tear proof) will be included in the kit with the driver. Rear wheels and tyres are the BRM Escort/Kaydett. 

Cheers

           JMay