[Farrout1]

Last weekend I got around to working on the ground in the pit area. Was always meant to be poured dark concrete with the appropriate groves etc. Here is how I did it. 

Basically:
1. Using knife cut the groves: two strokes using a straight edge in a V pattern
2. Use a black or dark wash to fill the groove
3. Wipe off excess but deliberately not too consistently. Leaves a lovely dirt pattern resembling dried pools fo water along edges of the depressions the groves sit in. 
4. Get a back massage because there is a lot of bending over involved
5. I just threw on the buildings and cars to give you a sense of scale. Certainly not near even a start on that stuff.