8th-Jan-22, 11:36 AM
(8th-Jan-22, 09:50 AM)BARacer Wrote: I noticed that the axle was rubbing on the motor casing to start with, so I had to smooth off some burrs to create an air gap between the two.just an FYI
both Slot.it SIPA01 and MBslot MB23749 ( maybe others ) produce 'reduced centre ' axles
this eliminates the clearance problem between the motor and axle
and i assume would reduce any possible magnetic drag ?
tbh jeremy , i only found this out recently when building MY 1st SW
use them as a matter of course now
Kev

![[+]](https://slotracer.online/community/images/bootbb/collapse_collapsed.png)