[chrisguyw]

First go with my new jig... 



Bit of work required to make the axles parallel to each other!

Hi Jeremy, unless they are hidden from view, you may want to seriously consider using your locating pins to hold/align the front axle............if the wheelbase is such that the holes in the front of the  jig do not allow a perfect wheelbase alignment,...you can move the rear pins to an alternate rear set of holes (the rear are slightly staggered to allow for this).

Cheers
Chris Walker

PS while this is not imperative on most plastic chassis (as the front axle does have some fore/aft movement),....for chassis with a front axle tube, or ,if you install one in your plastic chassis (a very good idea) the front axle locating pins are highly recommended