[Kevan]

My first resin printer was the Mars Pro, the build plate was a little small for 1/32 bodyshells so I had to tilt them at an angle but it got me into the world of 3D resin printing, I loved the quality of the final prints then I upgraded to a Photon Mono X which enables me to print any 1/32 car bodyshell flat on the build plate.

There isn't a smallest build plate unless you definitely prefer flat on the plate which has the #1 advantage of reduced TIME! Resin printers do one layer at a time so the height of the print is the killer if you have loads to print.