Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Gearing question
#5


Thanks for all the feedback. Really helpful.

Basically the track runs in a U-shape around the outside of the area but has quite a technical infield entered through a hairpin, into esses, a second hairpin and a smaller U-shape back to the start. So I'd say no straight is longer than 7' and generally 4'-ish.


It uses magnetic braid and the particular car (Slot.it Nissan R390 GT1) has stock Slot.it traction magnets. (They also run magless cars at times - but that's for another time.)

The motor is possibly a Slot.it V12/4 23000 rpm? (I'm the 'second user').

Pic' attached.

   

And yes, I had spotted the guide isn't connected to the motor.  Bigsmile  

An Oxigen 'C' chip is going to plug the gap  Thumbup
Quote


Messages In This Thread
Gearing question - by Top Down - 24th-May-21, 08:07 AM
RE: Gearing question - by BAracer - 24th-May-21, 08:26 AM
RE: Gearing question - by Nonfractal - 24th-May-21, 08:28 AM
RE: Gearing question - by Albion - 24th-May-21, 10:58 AM
RE: Gearing question - by Top Down - 24th-May-21, 12:26 PM
RE: Gearing question - by chrisguyw - 24th-May-21, 01:06 PM
RE: Gearing question - by Top Down - 24th-May-21, 01:48 PM
RE: Gearing question - by chrisguyw - 24th-May-21, 02:20 PM
RE: Gearing question - by Top Down - 24th-May-21, 06:07 PM
RE: Gearing question - by chrisguyw - 24th-May-21, 07:07 PM
RE: Gearing question - by Top Down - 24th-May-21, 07:37 PM
RE: Gearing question - by chrisguyw - 24th-May-21, 07:41 PM
RE: Gearing question - by Top Down - 25th-May-21, 06:39 AM
RE: Gearing question - by Nonfractal - 25th-May-21, 09:14 AM
RE: Gearing question - by Top Down - 25th-May-21, 12:04 PM

Possibly Related Threads...
Thread / Author Replies Views Last Post
Last Post by Kevan
23rd-Oct-24, 07:11 AM
Last Post by Kevan
7th-Oct-24, 07:07 PM
Last Post by Tibbs
4th-Oct-24, 07:48 AM
Last Post by WilkFrisk
7th-Nov-23, 06:00 AM
Last Post by CMOTD
17th-Mar-23, 03:46 PM
Last Post by Johnno
27th-Oct-22, 05:28 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)