[Savage GT]

Thank you Top Down.

A note to anyone else building the Dodge kit, I found with my two:

1. Front metal grill needs either careful trimming or folding of lower tab so as to not interfere with chassis.
2. Step/door rails need to be flexed to fit, I found the best way was to position bottom in hole and flex the side fixing down to the hole, then heat melt both.
3. The rear body post does not meet the chassis, so keep an eye on the rear when screwing the chassis on or else you will distort it.

Of course running some body float eliminates the last point anyways ;)

I also trimmed the axles so I had less tyre outside the bodywork, as I felt there looks too much on the stock setup of these cars. I am running 61mm front, 62mm rear to tyre outside edges on this pair.