[BAracer]

Matt

Thanks for your comments. I'm beginning to realise that in GT3, you need to think about every component, however minor.

So the wires coming out from the front of the chip are to the remote IR LED in the SureChange guide. Not sure if these have been raced with any success, but it helps me with tidying up the chip zone in the middle of the chassis.

With regards the motor pod, I have used the one from the donor car that did not come with outriggers. You cant seem to buy these separately so it looks like a new pod is needed to open up suspension tweaks. What offset do people generally go for?

With regards a 3D printed chassis with cut outs, yes, SA do sell one for the Porsche, but it was not clear to me reading the DiSCA regs that they were permitted...

2.1. Chassis may be any from the list of homologated chassis in section 7, including those supplied as original equipment with a model from the list of approved models. 
2.1.1. Non-specified aftermarket option chassis, e.g. soft versions, are illegal. 

Is it the case that they are specified aftermarket options. Do others race with these types of chassis? 

Is there a collection of GT3 race results somewhere that I can look through to see what cars others are using?

Hoping to test/race at Rockingham when it is possible again!