[Gordon Steadman]

               
I was sitting, as one does, staring at all the bits on the bench. I needed a pinion to fit the usual pressed tin contrates in Revell cars and the like and my eye fell upon the object in the picture. I'm sure most people know that those 'orrid gears eat pinions for breakfast.

Not this one I suspect as it's a cutter for a Dremel but...it meshes perfectly with the contrates! Apart from the problem of having a large shaft I can see a use for this. In a front motored car with back axle bearings to support it! Probably a bit of flexible hose to join it to the motor and voila.

Who says I don't try and be helpful.