[GregK]

[b][b]Ninco - Jaguar XK120: modified C8515 Rev H[/b][/b]
 
A variant of the Jaguar theme, the Olde Worlde XK120 floptop ......
 

For this car, I stripped all of the wiring off and replaced the infrared LED with one that
reached down and through the chassis. The wiring was kept to a minimum.
 
 

These cars do not have any meat in the front to anchor LEDs into so plastic tubes were
attached and dowsed in black paint to reduce the light bleed. For clarity, the wires have
not been added just yet.
 
 

This shows the rear light detail. Miniature LEDs were carefully fixed to the tubes with some
GC-Hypo cement. A couple of dabs on the resistors held them in place to aid the positioning
and soldering of the joints. The negative wire was added later, this was quite a stiff wire that
needed no support once fixed in place.
 
 

The next stage was to attach the wires from the LEDs to the circuit board.
 
 

Lights ON.......
 
 

Lights OFF ..............  
 
 

Whilst I was at it, I added another two .........  
 
 
I lurve Jags, I do