[chrisguyw]

Hello Ninco2000,....once you have cleaned the board (as described above),...it is highly recommended that you apply a drop of Inox, or SuperLube (a PTFE synthetic oil) to the wiper board, and squeeze the trigger a few times....(this is a recommended procedure voiced by most aftermarket high end controller manufacturers), and, I do not know of a long time racer that does not do this.

PS To male cleaning easier, you can remove 1 or 2 of the plastic ribs that cover the wiper board,....again, most folks do this, and it will have absolutely zero negative effect on the strength/integrity of the handle.

Cheers
Chris Walker