[Dr_C2]

Time to share a little playful project where I am experimenting with 2-part decoders. In this configuration the mainboard carries the diodes, microcontroller, strobe LED and, if required some lighting circuits. The MOSFET power control board is soldered directly onto the motor. There is a whole range of pros and cons with this type of configuration including future plug-and-play brushed versus brushless motor options. 

My main motivation for this project is to fit a high spec decoder into a slim F1 chassis. The decoder in the photo is equipped with 18A motor/brake MOSFETs. Perfect for 50k evo king motors on a heavily mag’ed drag strip setup :)




c