[Kevan]

Resin 3D printed highly modified Mini Cooper, pod and crew.

Carbon fibre reinforced PETG 3D printed chassis.

Two tone paint, metallic copper then a light spray at the front of metallic gold, it has a slight 'flip paint' effect. Molotow chrome highlights. All covered with two airbrushed layers of Vellejo lacquer.

...rear wheels/tyres are temporary, I'd really like to fit some NSR Special Blacks on smaller diameter wheels. Wheel inserts to be found/modified/resin 3DP.
Front axle will be split and independently rotating axles (it currently has one free spinning wheel captivated by a washer and short piece of brass tube soldered on the end).

This is the third one I've printed, the first was a bit of a disaster which needed a hole in the roof patching and I never got past the all black paint job.
The second was printed for a club mate about a year ago and was flying last week in our Minis & Mustangs race so I decided to revisit the body and tweak the chassis design a little.

Currently it's NSR Shark 25 powered, geared at 8/23 and should be a little rocket.