[Kevan]

I've printed pods of all kinds in the past but never really happy with them, especially SW where space is limited.

I've revisited my FC130 inline pod, tweaked it a fair bit and printed one in the same resin I use for bodyshells.

I've done pods for bronze bushings, ball races and SlotIt spherical bushings - all adjustable height.

This one is for spherical bushings, adjustable height motor and axle.

I've ditched a couple of features my pods used to have, one of which was a built in centre pivot.

   

I've not printed a pod for months but a few builds recently need an IL pod so I thought...why not, let's try it again...and I like it!