[OXO cube]

firstly i would like to say a huge thankyou to Leo Capaldi 
without him doing all the wiring etc i doubt i could have done this 
so thankyou Leo 

i have been using Ultimate Racer for a while now 
some like , some don't ... lets just say it suits my needs for my analogue track

previously i had cobbled together a functional Scalextric RMS system , but i wasn't happy with this flipper / switch type timing system 
so i needed something better 
this is where Leo comes in , i am rubbish at electronic type stuff , so was very happy when he offered his services 
i was thinking 'light bridge' using a Scalextric Dunlop bridge 
Leo sorted the wiring and upgraded ( imo ) to an IR system 
but the Dunlop bridge was too big for the position on the track i had in mind 
so i 3DP printed a bespoke bridge 
and everything works as it should 
           

if any one wants the bridge STL file , just let me know 
it just fits on my Ender3 Pro build plate with only 1/2mm to spare

Kev

why my pics always come out sideways ? i dunno