14th-Jun-21, 01:25 AM
Yikes...where has the time gone...?
I've 3D printed some guard rails, and done a little more turf work.
However, as it is now over 90 degrees and 75% or more humidity on a regular basis - simply running the air conditioning and de-humidifier isn't enough: my copper tape bubbles daily. EVERYWHERE. It is simple enough to re-burnish it, however then I get dead splices to deal with and it has come up over night and will not go back into place on some corners properly. Really takes the wind out of your sails after a busy day when all you want to do is run some laps.
So, I have purchased non-mag braid, a routing bit for the gains, and the tool to roll it all out with. That'll do the trick!
I hope to start working on that this week!
I've 3D printed some guard rails, and done a little more turf work.
However, as it is now over 90 degrees and 75% or more humidity on a regular basis - simply running the air conditioning and de-humidifier isn't enough: my copper tape bubbles daily. EVERYWHERE. It is simple enough to re-burnish it, however then I get dead splices to deal with and it has come up over night and will not go back into place on some corners properly. Really takes the wind out of your sails after a busy day when all you want to do is run some laps.
So, I have purchased non-mag braid, a routing bit for the gains, and the tool to roll it all out with. That'll do the trick!
I hope to start working on that this week!