[OXO cube]

hi Greg 
i struggle to get to your zoom meets
and have to watch later

but as an fyi 
i intend to enter the DAVOLS FORUM nascar proxy next time 
one of you attendees touched on it with some WC front axle info 
which i think was misunderstood ...

from the DAVOLS rules :-

Winston Cup Chassis: Stock plastic chassis from eligible manufacturers required. Sanding for float is allowed. Only mods described in the common rules allowed. Slot Car Corner Adjustable Front Axle Mounts may be used, front axle MUST remain in the stock height location. Stock front axle loops may be removed, but the lower section of rails must remain and will be used as the low point of the front axle.

hope this clears things up ... or i will need a new chassis 
kev