[Brumos RSR]

That was close!! Thank you for the video of the run and your team taking the time to host.  Congratulations to the winners.

[AdeC]

Event 2 video now live

[Kevan]

Nice track Ade  ...is it me or is this new track much quieter than your previous one as there seems much less of a plastic track sound.

[AdeC]

Nice track Ade  ...is it me or is this new track much quieter than your previous one as there seems much less of a plastic track sound.

It's the same track we've had the last few years; although it is quieter than the Scalextric Sport track we had a few years ago. It tends to be noisy if people glaze their front tyres (or use very hard tyres) because of the rough surface.

[AdeC]

Could you put a strip of tape about 10mm wide down and under the chassis just to stop it moving please.

If I'd seen an issue like that with a car at our round of the proxy I'd secure the body like I just mentioned above, to make sure it was OK to race.

Yes, that's what we did. Not perfect, but should hopefully prevent the risk of weakening the other mounts....

   

[Kevan]

Thank you. 
I used a different super glue (cheaper) to fix these body mounts into the bodyshell, I will be going back to the tried and tested red and yellow UHU super glue in future.

[AdeC]

Sorry for the delay with the Event 3 footage.  Been busy with work.  Will hopefully have it uploaded in the next day or two

[AdeC]

Sorry for the delay chaps... Here is the event 3 video.  As you may have seen on the event 2 video, my GoPro ran out of battery part way through event 2.  This meant I had to switch to my phone which I wasn't planning on. Needless to say, my phone promptly ran out of storage (as you will see as one heat of event 3 get's cut short). Luckily I was able to make some room and film the remaining heats.