Having been out of the loop, but looking forward to helping Brian (CMOTD) run his hosting round of the proxy, I was saddened to hear about DHL's carnage. The effort Graham goes to to organise and pack...

A milestone has been reached, its "only" taken me 18 months since the boards were in place.  :rofl: But today the lower level track work has finally met up, just around 2.5m of wiring to complete ......

I did warn you it would be a slow burner ! Today I got the base rust and sleeper grime coat down on the goods yard area (the only track in place and pinned atm). Once painted and top of the rails cle...

The Ender 3 V2 Neo has done a good few bits for me, but even though its not used daily, after a couple of years there are problems, The temperature sensor for the nozzle has been intermittently waywar...

Just got back from helping Brian. I have to say all of the cars were running well, usually there's at least one or two I don't get on with, but a lovely looking bunch that were all fun to drive, well ...

It has been a while and not a lot to add, but I have 3DP myself some point jigs for frog wires, point motor and dropper wire holes. I also had time to contemplate th growing collection of Loco's, and...

Trying to achieve an old photo look with limited skills: [attachment=37582]

Still lots of little detail work to do, but a few pics taken today: [attachment=37577] [attachment=37578] [attachment=37579] [attachment=37580] [attachment=37581]

My 2 also arrived safely, thanks Graham  :cool:

Shedingarden's RC software was fully sorted on Wednesday, and the Trio of regulars met up again.  After lunch we were joined by Tony who proceeded to make us all look slow !   An enjoyable race meetin...

Well done all the winners, and thank you Graham for hosting another great event.  :yes:

The intrepid trio met up again, thankfully Brian was feeling up to hosting, so another day of banter and racing ensued at Conington. Some of Brian's newly acquired stock got a run out with the Pioneer...

The rest of the lower level now cut and temp pinned in place. [attachment=35826] [attachment=35827] The lift out section, I was going to use the loose pin hinges, to join, but this seemed a bit "cl...

No Anthony this is OO, all the track is Peco bullhead, a much closer representation of British steam era track, in terms of rail profile and sleeper spacing. The joiner plates are made to look a lot c...

Had you considered Policar track to replace the damaged SCX ?

A slow burner for sure, but starting to make some progress now. The shunting yard and dock area track cut, shaped and temporarily thumb tacked, very therapeutic that was, despite the fiddly track join...

Slot.It Nissan R390 SOLD

Generally its inside (slot.it, NSR), although the newer Slot its will fit both 15.8 and 16.5, inside on the 16.5 outside on the 15.8. Sideways are outside fittings. NSR and Slot.it are slighty differe...

No, I wasn't prepared to pay the (then very pricey, no idea if better now) shipping + risk possible import fees. Pity, I bet they would sell well over here.

Scalextric Mclaren F1GT with Amato Chassis X2 SOLD