hello, when i was working on my ninco track and the ds 35ohm regulator this afternoon, it started to smell a bit burning, later i noticed that there were also some sparks visible on the gold strip of...

hello, i have a nice regulator of ds of 35ohm. now the inside is getting a bit black (as can be seen in the picture) my question is, how exactly does this happen, and how and with what is this easy t...

Are those pin Numbers the same for software like a Race  coördinator ?

hi Leo, thanks for your answer, so I understand that the 25 pin must be connected the same as the 9 pin connector... I'm finally going to start working on it again this afternoon, and hope to get it ...

hello, thank you for your answer, the specialist here indicated that Carrera was the best for digital (agreeing with that, but it's a shame if you have so much Ninco), I then asked about the possibil...

Hello, a burning question here :) I have a decent track length from ninco, which I am still very satisfied with. Now I really want to do more with digital in the near future. Since Ninco is really...

If I have installed the printer port in my PC, which pin numbers should I solder, and what do I indicate in laptimer 2000 under the heading ports? Robbin

I'm going to buy a D-Sub 25 connection and connect it to the PCI port on my motherboard, then I can switch the pins and it should work, this will arrive on Tuesday and I'll know if it works Robbin

hello leo, I just saw your message, I have been working intensively on it today, I can't get it to work either, I have attached some photos of the situation, Do you happen to know if there is othe...

hello leo, Thank you again for this clear explanation, I know what I have to do, I am going to order what I need today, and once everything has been delivered I will start working on it straight away...

they are mainly FLY cars, and some Ninco models, luckily no flames or smoke seen yet ;)

ah thanks for the answer, I was wondering if it could do a lot of harm before I destroy my new controllers  ahaha

hello, I recently bought a new controller, a DS 35 ohm, which gets hot over time. I had never actually noticed it with my old controllers, but I was wondering if this is normal and if so, why? I'd l...

hello leo, I already ordered the photo diodes, I still have a piece of audio cable lying around so that's good ;) the only thing left is the last piece of audio cable to PC. If you can send a draw...

Hello Leo, thanks again for the answer, I will look for photo diodes, the photo below the track is very clear, thanks for this. What I don't quite understand yet is how I would go from the audio cab...

I have added 2 photos, 1 of the diode that I think I need (Light sensor / Phototransistor HW5P), and 1 of the cable that I think I need. is this all or is more needed?

Leo, thanks again for the help, laptimer 2000 works (as I now see) without any problems on my PC, I now understand what kind of cable I need and how to solder to the cable. The only thing that is not ...

If all goes well, I have attached a photo of the back of my PC, the PC is a bit older but new enough to run Windows 10 :) thank you very much for the photos, this already clarifies a lot, where you g...

Hello and thank you very much for your answer and help, on my pc that runs on windows 10 there is currently a connection with 9 of those pins (as can be seen in the blue section) i am from the Net...

Scuderia_Turini, thanks for your answer, this already clarifies a lot, do you have any examples of what I need under the track to go to a 25 parallel port?