SlotRacer Forum
Revoslot Ferrari 333SP A white kit - one part puzzling me - Printable Version

+- SlotRacer Forum (https://slotracer.online/community)
+-- Forum: Slot Cars (https://slotracer.online/community/forumdisplay.php?fid=3)
+--- Forum: 1:32 Scale (https://slotracer.online/community/forumdisplay.php?fid=4)
+--- Thread: Revoslot Ferrari 333SP A white kit - one part puzzling me (/showthread.php?tid=4691)


Revoslot Ferrari 333SP A white kit - one part puzzling me - Makem - 9th-Jan-25

I am building up a Revoslot Ferrari 333SP A White kit
I am stumped on where the exhaust block fits.

Usually it is obvious but not to me, bit baffled.

Please don't say at the back. Tease

Regards
Gerry

RE: Revoslot Ferrari 333SP A white kit - one part puzzling me - BAracer - 9th-Jan-25

Photos on the PSR site of the finished car would suggest that you have a rogue component there...the pipes should run in the same direction as the rear diffuser fins.

RE: Revoslot Ferrari 333SP A white kit - one part puzzling me - Kevan - 9th-Jan-25

If it's injection moulded it'll be impossible to make it wrong, I suggest that's not an exhaust we're looking at.

RE: Revoslot Ferrari 333SP A white kit - one part puzzling me - JasonB - 9th-Jan-25

Could what looks like the exhaust pipes, instead be lugs to allow the attachment of the diffuser?

Brumos RSR - Brumos RSR - 9th-Jan-25

It’s upside down in your picture it should line up under the rear spoiler

RE: Revoslot Ferrari 333SP A white kit - one part puzzling me - Graham - 9th-Jan-25

This is what my RTR version looks like fitted from underneath

RE: Revoslot Ferrari 333SP A white kit - one part puzzling me - Makem - 9th-Jan-25

Thanks, once you told me that it isn't an exhaust I can see where it goes now.
Silly old man.
Gerry

RE: Revoslot Ferrari 333SP A white kit - one part puzzling me - Graham - 9th-Jan-25

(9th-Jan-25, 05:24 PM)Makem Wrote:  Thanks, once you told me that it isn't an exhaust I can see where it goes now.
Silly old man.
Gerry

The exhausts are in silver and are part of the valence moulding so they only show end on.