Goldrock revival - Printable Version

Goldrock revival - Printable Version

+- SlotRacer Forum (https://slotracer.online/community)
+-- Forum: Tracks & Scenery (https://slotracer.online/community/forumdisplay.php?fid=8)
+--- Forum: Show us your track (https://slotracer.online/community/forumdisplay.php?fid=9)
+--- Thread: Goldrock revival (/showthread.php?tid=3491)

Goldrock revival - OXO cube - 21st-Jan-23

after alot of headache
my new garage / man cave has been finished
and the track rebuild has begun to take shape
the original Goldrock track was housed in a pre-fab garage dating from the early 60's
the roof was asbestos , the concrete panels also contained asbestos and it was not insulated which lead to corrosion of the rails and freezing temperatures in winter
the new building is block construction , fully insulated ( walls , floor , roof ) and has been quite cozy , even during this recent cold snap
[attachment=28231] original layout
[attachment=28232][attachment=28233][attachment=28234][attachment=28235]
original layout had a couple of elevations , have decided to remove these for this layout , but as usual things can and will most likely change
table is 16' x 4' with a 3' x 3' dog leg at the far end resulting in a track length of approx 85'
still lots to do , especially the 3dp borders , but will be complete well before hosting Graham's rally proxy this year :) the rally section will be constructed / designed nearer the event
Kev

RE: Goldrock revival - Serpico - 21st-Jan-23

Like the barriers in red and white between the 2 corner radius. Where did you get them or did you make them yourself?

RE: Goldrock revival - Scuderia_Turini - 21st-Jan-23

Looking good Kev, a fresh start is always a good move. Flooring looks ood too!

Leo

RE: Goldrock revival - OXO cube - 22nd-Jan-23

(21st-Jan-23, 08:12 PM)Serpico Wrote: Like the barriers in red and white between the 2 corner radius. Where did you get them or did you make them yourself?

hi serpico
these barriers are a modification of Greg Gaubs flexible 3dp barriers
yes , home made on my printer
the file can be found here :-
slot car crash barrier by OXO_cube - Thingiverse
print any colour you like
kev

RE: Goldrock revival - OXO cube - 22nd-Jan-23

(21st-Jan-23, 10:52 PM)Scuderia_Turini Wrote: Looking good Kev, a fresh start is always a good move. Flooring looks ood too!

Leo

thanks Leo
worlds away from the old room / garage Thumbup

Kev

RE: Goldrock revival - OXO cube - 9th-Feb-23

https://youtu.be/6JJnCWkS57o

so far :)

paul.cooper.22@googlemail.com - PaulCooper - 10th-Feb-23

Looking good ? its going to be a nice quick rally stage …tarmac ..good luck .