Small crown and pinion set - Printable Version

+- SlotRacer Forum (https://slotracer.online/community)
+-- Forum: 3D Printing (https://slotracer.online/community/forumdisplay.php?fid=56)
+--- Forum: 3DP (https://slotracer.online/community/forumdisplay.php?fid=57)
+--- Thread: Small crown and pinion set (/showthread.php?tid=3264)

---

Small crown and pinion set - AlexisGaitanis - 27th-Sep-22

I have been building a car for some time now and the last obstacle was there was not enough room for the rear tyres,i turned them down bu then hit another probl;em,crown was touching down.After some thought i decided to venture a small crown and pinion set and it worked.The crown is 27z 13.7 diameter and the pinion is 9z for 1.5 dia shaft
[attachment=26415]
Comparison to a slot.it crown
[attachment=26416]
I have uploaded them on cults

---

RE: Small crown and pinion set - chappyman66 - 27th-Sep-22

Very nice work sir.

---

RE: Small crown and pinion set - GT40Racer - 28th-Sep-22

Nice work 
What resin did you print them with?

thanks
David

---

RE: Small crown and pinion set - Kevan - 28th-Sep-22

(28th-Sep-22, 11:09 PM)GT40Racer Wrote:  Nice work 
What resin did you print them with?

thanks
David

Looks like Siraya Blu...I don't expect it to last long...

---

RE: Small crown and pinion set - AlexisGaitanis - 29th-Sep-22

(28th-Sep-22, 11:09 PM)GT40Racer Wrote:  Nice work 
What resin did you print them with?

thanks
David

Siraya build

---

RE: Small crown and pinion set - Kevan - 29th-Sep-22

I wonder if you can get resin parts hard plated.

---