Set up plate & drivers - Printable Version

+- SlotRacer Forum (https://slotracer.online/community)
+-- Forum: 3D Printing (https://slotracer.online/community/forumdisplay.php?fid=56)
+--- Forum: 3DP (https://slotracer.online/community/forumdisplay.php?fid=57)
+--- Thread: Set up plate & drivers (/showthread.php?tid=2564)

---

Set up plate & drivers - JMay - 13th-Nov-21

Some useful tools.

Set up plate for cars

[attachment=19387]
Can be used either side with car sitting on wheels or wheels suspended over the wells.

[attachment=19386]
M4 hex handle for when you get fed up swapping the driver bits over in the only handle you have.

[attachment=19384]
1/4 socket driver spinner, useful when accessing tight areas i.e. removing the hot nozzles from the printer without having to jack the gantry skyward.

And the STLs.

[attachment=19388]

[attachment=19385]

[attachment=19383]

Depending on the various print variations the hex fit and 1/4 drive may need some finessing to get the right fit i.e. tight enough to be held upside down and can still be removed without swearing.

Cheers JMay

---

RE: Set up plate & drivers - Kevan - 13th-Nov-21

I printed a handle a while back, it's a little small but super useful as I've got a small 3 jaw chuck with a hex drive on it which is perfect for hand drilling etc.

---