Ferrari 350 CanAm - Printable Version

+- SlotRacer Forum (https://slotracer.online/community)
+-- Forum: Slot Cars (https://slotracer.online/community/forumdisplay.php?fid=3)
+--- Forum: Scratch Building (https://slotracer.online/community/forumdisplay.php?fid=35)
+--- Thread: Ferrari 350 CanAm (/showthread.php?tid=176)

---

Ferrari 350 CanAm - AlexisGaitanis - 25th-Apr-19

Phil Klabfell body,started ages ago and remained unfinished until recently,my entry to Can Am HRW Proxy.Torsion bar chassis,slimline $2 motor NRS ultragrips at threar 

[attachment=699]

[attachment=700]

[attachment=701]

[attachment=702]

[attachment=703]

---

RE: Ferrari 350 CanAm - Anthony B - 25th-Apr-19

One of favourite cars of all time   Nice Job!!

A few of my builds over the years

First - a John Bacon Fibreglass body that I set up as the Love/Hawkins car that raced at Kyalami.

[attachment=708]

Then a Patto's PTG type body with fly chassis:

[attachment=709]

And Lastly the one in my collection now - also a John Bacon body with Brass chassis built for Bordo but the motor I had was too powerful and was left in the pit box :

[attachment=710]


Good luck with your entry - keep us updated on how it goes.

---

RE: Ferrari 350 CanAm - kalbfellp - 25th-Apr-19

Good to see the body finally finished.Looks good.
I have just started to revise the master for a new mould.

---

RE: Ferrari 350 CanAm - munter - 25th-Apr-19

Put me down for a body kit please, Phil.

---

RE: Ferrari 350 CanAm - Beejay7 - 26th-Apr-19

Nice work Alexis....and interested to see what you are going to do with the shell Phil.

Regards

Alan

---

RE: Ferrari 350 CanAm - kalbfellp - 26th-Apr-19

Not a lot Alan, the original mould is starting to break up. So the rear panel needs a slight alteration and the duct under the nose is not correct. Also a new vac formed interior. Just need some time.

---