SlotRacer Forum
Global Touring Cars Challenge -Rounds & Results - Printable Version

+- SlotRacer Forum (https://slotracer.online/community)
+-- Forum: Racing (https://slotracer.online/community/forumdisplay.php?fid=27)
+--- Forum: Proxy Racing (https://slotracer.online/community/forumdisplay.php?fid=42)
+--- Thread: Global Touring Cars Challenge -Rounds & Results (/showthread.php?tid=5298)

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17


Brumos RSR - Brumos RSR - 30th-May-26

That was close!! Thank you for the video of the run and your team taking the time to host.  Congratulations to the winners.


RE: Global Touring Cars Challenge -Rounds & Results - AdeC - 1st-Jun-26



Event 2 video now live


RE: Global Touring Cars Challenge -Rounds & Results - Kevan - 1st-Jun-26

Nice track Ade Thumbup ...is it me or is this new track much quieter than your previous one as there seems much less of a plastic track sound.


RE: Global Touring Cars Challenge -Rounds & Results - AdeC - 1st-Jun-26

(1st-Jun-26, 11:08 AM)Kevan Wrote:  Nice track Ade Thumbup ...is it me or is this new track much quieter than your previous one as there seems much less of a plastic track sound.

It's the same track we've had the last few years; although it is quieter than the Scalextric Sport track we had a few years ago. It tends to be noisy if people glaze their front tyres (or use very hard tyres) because of the rough surface.


RE: Global Touring Cars Challenge -Rounds & Results - AdeC - 1st-Jun-26

(30th-May-26, 10:00 AM)Kevan Wrote:  Could you put a strip of tape about 10mm wide down and under the chassis just to stop it moving please.

If I'd seen an issue like that with a car at our round of the proxy I'd secure the body like I just mentioned above, to make sure it was OK to race.

Yes, that's what we did. Not perfect, but should hopefully prevent the risk of weakening the other mounts....

[attachment=47441]


RE: Global Touring Cars Challenge -Rounds & Results - Kevan - 1st-Jun-26

Thank you. 
I used a different super glue (cheaper) to fix these body mounts into the bodyshell, I will be going back to the tried and tested red and yellow UHU super glue in future.


RE: Global Touring Cars Challenge -Rounds & Results - AdeC - 3rd-Jun-26

Sorry for the delay with the Event 3 footage.  Been busy with work.  Will hopefully have it uploaded in the next day or two


RE: Global Touring Cars Challenge -Rounds & Results - AdeC - 15th-Jun-26



Sorry for the delay chaps... Here is the event 3 video.  As you may have seen on the event 2 video, my GoPro ran out of battery part way through event 2.  This meant I had to switch to my phone which I wasn't planning on. Needless to say, my phone promptly ran out of storage (as you will see as one heat of event 3 get's cut short). Luckily I was able to make some room and film the remaining heats.


RE: Global Touring Cars Challenge -Rounds & Results - Graham - 17th-Jun-26

The next 2 rounds are being run next week in the North East England.


Tyneside Slot car Club
[attachment=47530]


Wearside Slot Car Club
[attachment=47529]

I understand there could be an attempt at live streaming for these rounds


RE: Global Touring Cars Challenge -Rounds & Results - Kevan - 17th-Jun-26

That's two nice setups you guys have  Thumbup