AlexisGaitanis's Forum Info
Registration Date:
21st-Apr-19
Last Visit:
6 hours ago 10:21 AM
Total Posts:
155 (0.28 posts per day | 1.44 percent of total posts)
(Find All Posts)
(Find All Posts)
Total Threads:
40 (0.07 threads per day | 2.52 percent of total threads)
(Find All Threads)
(Find All Threads)
Time Spent Online:
2 Days, 5 Hours, 32 Minutes
(Find All Threads Liked For — Find All Posts Liked For)
(Find All Liked Threads — Find All Liked Posts)
Additional Info About AlexisGaitanis
Gender:
Undisclosed
| AlexisGaitanis's Most Liked Post | |||||
| Post Subject | Numbers of Likes | ||||
| My first hillclimb | 6 | ||||
|
|||||
| Post Message | |||||
| I wanted to give it a try for very long,finally I found time to build it.Since it has to be easily transported,and will be stored in a covered but open area therefore has to be light and with stand humidity.The solution I found was styrofoam.I had already experimented with a couple of special stages,one single board(250 X60 cm) each .The big issue was if I would be able to bend the board.Which I succeded.I used a single board for this one too because I wasnt sure if bonding 2 pieces would be strong enough.I used pva glue and pu foam which worked quite well.Unfortunately I did not think of taking photos in the proccess but I shot a short video from the firat run.First impressions: -ground clearence has to be at least 1.5 -BREAKS ,the first car that touched the track ended on the floor at the end of the downhill section -sprung guide or drop arm a must -guard rails and walls have to be added Planning for the next one,this time I will shoot hpotos and it will be more car friendly For the time being here is a short video [video][/video] |
|||||