niklasw
(Junior Member)


Registration Date: 18th-Nov-23
Date of Birth: Not Specified
Local Time: 7th-Dec-23 at 09:46 PM
Status: Offline

niklasw's Forum Info
Registration Date:
18th-Nov-23
Last Visit:
24th-Nov-23, 07:56 PM 07:56 PM
Total Posts:
4 (0.21 posts per day | 0.01 percent of total posts)
(Find All Posts)
Total Threads:
2 (0.11 threads per day | 0.05 percent of total threads)
(Find All Threads)
Time Spent Online:
1 Hour, 16 Minutes, 4 Seconds
Total Likes Received: 7 (0.37 per day | 0.01 percent of total 47452)
(Find All Threads Liked ForFind All Posts Liked For) Total Likes Given: 9 (0.48 per day | 0.02 percent of total 47496)
(Find All Liked ThreadsFind All Liked Posts)

niklasw's Most Liked Post
Post Subject Numbers of Likes
Built a track in Sketchup - collecting parts 3
Thread Subject Forum Name
Built a track in Sketchup - collecting parts Planning
Post Message
Hi
First post for me. I have been planning this track for a long time and I have been collecting parts for a long time. I recently managed to finally find a 2nd hand ArcPro for about €200 including lots of track pieces and three worn out F1 cars. So now I am getting ready to make this finally happen for real! I've attached in progress image of my plan using SketchUp. I have almost all pieces needed apart from the pit lane.

Open for feedback!

Question: As mentioned I plan to use ArcPro and was wondering if it possible to run digital Scalextric with a variable powwer supply? And if so how do I go about hooking it up?